Difference between revisions of "EGR 103/DAQ Audio 1"

From PrattWiki
Jump to navigation Jump to search
Line 1: Line 1:
 
== Volume Control ==
 
== Volume Control ==
 
=== Optiplex 755 ===
 
=== Optiplex 755 ===
 +
In general, do '''not''' follow the writeup; instead, turn all the possible volumes on and set them all to 80%.
 +
 
If you are on an Optiplex 755, do the following:
 
If you are on an Optiplex 755, do the following:
 
# Open the Volume Control Panel
 
# Open the Volume Control Panel

Revision as of 17:48, 6 November 2008

Volume Control

Optiplex 755

In general, do not follow the writeup; instead, turn all the possible volumes on and set them all to 80%.

If you are on an Optiplex 755, do the following:

  1. Open the Volume Control Panel
  2. Go to Options, Properties, pick Recording, and make sure all of them are on
    1. Select "Rear Input"
    2. Set this volume about 80% on
  3. Change "Recording" to "Playback"
    1. Make sure all are on
    2. Set all volumes to 80%

Oscilloscope

Sample Screens

Proper Setup

Here is an example of a sound file being played at the right volume:

GoodScope.JPG

Too Loud

Here is an example of a sound file being played at too high a volume:

ClippedScope.JPG

Note that the top of the signal hits 10 divisions above the Ch1 pointer. Basically, the signal may be going above 0.5 V, but the DAQ card is not set up to handle voltages that high, so it "clips" the value to 0.5. This will lead to poor sound quality.


Won't Stop!

If the "stop" button does not seem to work, just close the whole oscilloscope.


Weird Errors

The following have been happening semi-randomly:

  • softscope issues:
    • Opening softscope gives an error about the GUI - restart the computer you are on.
    • The "stop" button will not work - close the softscope window. This may lead to the following problem:
    • Closing softscope closes MATLAB - just restart MATLAB. This may happen a couple times... If it keeps happening, just use softscope to get your volumes correct, restart MATLAB, then skip to the next part of the lab without reopening softscope.