User:DukeEgr93/Arduino 110

This page will serve as development space for the ECE 110 conversion to Arduinos.

Document Preparation

Section Completion

Section	Last Update	Status	Notes
Preface	12/19/2013	Ready
Updates	12/19/2013	Ready	removed
Acknowledgments	12/19/2013	Ready
Lab 1	12/19/2013

Lab 1

Connecting the Parallax Digital Trainer to the BOE Shield

This requires two male-to-male 3-header cables.

• The first cable will go from channels GND/13/12 on the BOE Shield to channels GND/P0/P1 on the PDT. The black wire should be on GND; for the BOE Shield, that is the second-to-leftmost pin on the top bus while for the PDT, that is the fourth pin from the top on the left of the socket.
• The second cable will go from channels 2/3/4 on the BOE Shield to P2/P3/P4 on the PDT. The black wire should be on pin 2 of the BOE Shield and in the sixth-from-the-bottom socket on the PDT. The white wire should be on pin 4 of the BOE Shield and in the fourth-from-the-bottom socket on the PDT.